Theta Dreadnought D
Analog Audio Inputs
1 Single-ended (RCA) per channel on each module.
1 Balanced (XLR) per channel on each module.
47 kOhms. Single-Ended or Balanced, each phase.
Mono or Stereo module:
Single-ended) 1.825V RMS input for 225W into 8 ohms.
Balanced) 1.825V RMS input for 225W into 8 ohms.
Mono Bridged module
Single-ended or Balanced) 1.825V RMS input for 500W into 8 ohms
(Single-Ended or Balanced) 27.8dB.
(Balanced) Pin-2 = Positive, Pin-3 = Negative for Non-Inverting Output.
Analog Audio Outputs
One balanced output with 5-way binding posts per channel.
Standby: Amplifier is ready to be turned on via front panel switch or remote trigger.
Overcurrent, D.C., and/or thermal protection: Amplifier will cycle.
Catastrophic D.C. or output stage failure: Amplifier will shut down.
Mono or Stereo Module
8 ohms: 225W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz:
4 ohms: 375W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz.
2 ohms: 500W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz.
Mono Bridged Module
8 ohms: 500W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz
4 ohms: 800W RMS per channel with less than 0.05% THD from 20 Hz to 20 kHz.
+0, -.5 dB 0Hz to 20 kHz, load independent.
Greater than 6000 at 100 Hz; Greater than 2000 at any frequency up to and including 20 kHz.
Signal to Noise Ratio
120dB referenced to rated output (A-Weighted)
117V AC, 15A Slo BLo main fuse: 230V AC 8A Slo Blo main fuse; 50/60 Hz
Less than 1W at Standby; less than 80W at idle; 1500W maximum by 2 when fully loaded
5 to 12V DC; Steady State.
(W x H x D) 17 5/8 inches x 7 15/16 inches x 19 3/4 inches; 448 mm x 202mm x 502 mm
(fully loaded) 98.5 lbs; 44.8 kG
111 Lbs. Boxed with accessories (50.4 Kg)
Maximum Operating Temperature
Internal: 176° F (80° C)
Room: 122° F (50° C)
Specifications subject to change without prior notice.
Contact Us For Details!